Step by step instructions on how to replace the cartridge of your RESPIMAT® inhaler
Cartridge replacement is straightforward. The dose indicator will let you know when you need to do this. 1
Reading the dose indicator 1
The dose indicator shows the number of remaining doses.
Yellow means there are only 10 puffs left and you will need a new cartridge soon.
Red tells you when the cartridge is used up and needs replacement.
Steps for cartridge replacement 1
1. Remove clear base
-
Keep the cap closed
-
Press the grey safety catch on the side of the RESPIMAT® inhaler while firmly pulling off the clear base with your other hand
-
Pull off the cartridge from the inhaler. Insert a new cartridge
2. Insert cartridge
-
Insert the narrow end of the cartridge into the inhaler
-
Place the inhaler on a firm surface and push down firmly until it clicks into place
3. Track cartridge
-
Mark the check-box on the inhaler's label to track the number of cartridges
-
Put the clear base back into place until it clicks
Steps for activation
Turn
-
Keep the cap closed
-
Turn the clear base in the direction of the arrows on the label until it clicks (half a turn)
Open
-
Open the cap until it snaps fully open
Press
-
Point the inhaler towards the ground
-
Press the dose release button
-
Close the cap
Repeat the Turn – Open – Press until a cloud is visible, then repeat 3 more times -
Your inhaler is now ready to use and will deliver 60 puffs (30 doses)
You can use up to 6 cartridges with your RESPIMAT® inhaler 1
New cartridges are available in refill packs that contain up to three cartridges.
References
-
Dalby RN, et al. Med Devices (Auckl). 2011;4:145-155.
-
Dalby R, et al. Int J Pharm. 2004;283(1-2):1-9.
-
Placebo RESPIMAT® Instructions for use. October 2018.
-
Anderson P. Int J Chron Obstruct Pulmon Dis. 2006;1(3): 251-259.